Riverton Rovers
Shoshoni WY 82649
Well it the Aussie truck has made it to Wyoming! What a nice truck, It has the Holden (Chevrolet) inline 6 cyl, Fairey overdrive, locking front hubs, defender front seats. It has a Salisbury rear axle, good door seals, the drive train all feels tight and smooth. When the engine conversion was done they installed the radiator out of the Holden, I did not like it so I put in a bigger heaver radiator out of a series IIA I aslo installed a thermostatically controlled fan and now I am happy with it. I also replaced the speedo cable. I just gave it a tune up, points, cleaned the cap and rotor. I removed the plugs and cleaned and re-gaped then as well It runs like a top! All in all a good solid truck.
$8900.00
MOVED TO THE WORKSHOP PAGE!!!
I just got this Series IIA 109 pickup in. It is very stock and un molested. It has a kodiak heater. No rust anywhere! It runs quite well, starts right up when the start button is pressed. No smoking on startup or after it has ran for a while. The brakes are good, and the clutch works well too. The drive train all seems to be in very good working order. No strange noises or bumps. The body needs some attention however. Aside from that dandy paint job it need a L/R quarter panel. Both of the front outer wings are pretty banged up. The front of the left fender needs replaced too. The rear cross member is pretty bent up as well. It has some other minor body damage that is quite fixable. I have all the parts to repair the body except for the quarter panel. The seats need recovered as well.
$6500.00
I picked up this SIIA 109It has a really nice body and some cool stuff but it is rusty and needs work The bulkhead needs some repairs, the foot wells need repairs and the frame needs replaced. It is worth saving but I dont have time at the moment. It could be one of those 20,000 dollar trucks. I am going to keep the roof rack, and I have most all the parts required to fix this truck up.
For now 4800.00 as is
Here we have a 1973 Series III 88.
Being a Wyoming truck it does not have any rust issues. It does however have a homemade steel front fender! Both the front fenders are pretty torn up and in need of replacement. It has a fresh 2.25 liter gas engine. It also has freewheeling front hubs. I have installed a new fuel tank and flushed the lines out. It needs a carburetor overhaul. I have a kit on order. The brake master cylinder is shot and I have one coming too. I did start it and drive it around some and it feels tight and good.
$4500.00
If you see anything here you like send an email to bill@rivertonrovers.com or call 307-856-4022
